Though my input and output data is inversely proportional, system identification toolbox is giving me a positive gain

2 次查看（过去 30 天）
Saraswathi S
Saraswathi S 2021-8-11
回答： Dhruv 2024-5-2
Hello all. I have a set of input and output data collected from a process. As my input increases, my output decreases and so technically my gain should be negative. But when I load the data in system identification app, and estimate using process models, Im getting a huge positive gain. Where could be the potential mistake?

请先登录，再回答此问题。

回答（1 个）

Dhruv
Dhruv 2024-5-2
Hi Saraswathi,
There might be some areas where you can check for potential issues:
  1. Data Preprocessing: Ensure your input and output data are correctly aligned and preprocessed. Any inconsistencies or noise in the data might affect the model estimation.
  2. Model Selection: Verify that the chosen model in the System Identification Toolbox is appropriate for capturing the dynamics of your system, including any inverse relationships.
  3. Parameter Initialization: The initial guess for the model parameters can significantly influence the estimation results. Consider providing a manual initial guess that reflects the expected negative gain.
I hope these checks will help you identify and correct the issue.

类别

在 Help Center 和 File Exchange 中查找有关 Linear Model Identification 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by