Stop Time and Sample time for best performance
显示 更早的评论
I create an RLC circuit in the Picosecond range, but when I started simulation its take a long time to finish the simulation.
What is the relation between sample time and stop time for simulation in this range for best performance?
回答（1 个）
Joel Van Sickel
2021-8-18
0 个投票
Hello Mohamadreza,
the default stop time is 10 seconds. You can set this time to anything you want. Your stop time is directly proportional to how long your simulaiton will take. you should only simulate your system long enough to see the relevant dynamics that you need to observe. A good point to start with for stop time in a system in the picosecond range would be 1 nano second of simulation. There is no relationship to stop time and sample time, but they both affect how long it takes to finish the simulation.
Regards,
Joel
类别
在 帮助中心 和 File Exchange 中查找有关 Multibody Modeling 的更多信息
2021-8-15
2021-8-18
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
