how to run a MATLAB model through GUI
2 次查看(过去 30 天)
显示 更早的评论
i need to run a MATLAB model from GUI ,i had used sim command but i cannot see the simulation time , i need to see the simulation timing. I used following command "set_param(gcs,'SimulationCommand','start')"but when i run from GUI model run but i cannot see the scope waveform.can u suggest me how can i run a model from GUI and can see simulation percentage or timing
0 个评论
回答(1 个)
Zack Peters
2013-10-25
Hi Milan,
If you save a model with the scopes open and then close the model, then the next time that you open that model, the scopes will open as well.
When you start the model via set_param you will get a full view of the model's simulation time at the right side of the model's status bar as well as continuous updating of the scopes.
You can see from executing the following code in the command window (try to simplify by taking the GUI out of the equation):
open_system('vdp')
set_param('vdp','SimulationCommand','start')
~Zack
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 View and Analyze Simulation Results 的更多信息
产品
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!