清空筛选条件
清空筛选条件

how to run a MATLAB model through GUI

3 次查看（过去 30 天）
Milan
Milan 2013-10-22
评论： Phani kumar KSV 2020-4-23
i need to run a MATLAB model from GUI ,i had used sim command but i cannot see the simulation time , i need to see the simulation timing. I used following command "set_param(gcs,'SimulationCommand','start')"but when i run from GUI model run but i cannot see the scope waveform.can u suggest me how can i run a model from GUI and can see simulation percentage or timing

请先登录，再回答此问题。

回答（1 个）

Zack Peters
Zack Peters 2013-10-25
Hi Milan,
If you save a model with the scopes open and then close the model, then the next time that you open that model, the scopes will open as well.
When you start the model via set_param you will get a full view of the model's simulation time at the right side of the model's status bar as well as continuous updating of the scopes.
You can see from executing the following code in the command window (try to simplify by taking the GUI out of the equation):
open_system('vdp')
set_param('vdp','SimulationCommand','start')
~Zack

类别

在 Help Center 和 File Exchange 中查找有关 View and Analyze Simulation Results 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by