![photo](/responsive_image/150/150/0/0/0/cache/matlabcentral/profiles/1703167_1522087876100_DEF.jpg)
Pooja
自 2013 起处于活动状态
Followers: 0 Following: 0
Research Scholar
Professional Interests: Wireless Communication, Automatic Control
Feeds
提问
Regarding configuremodelsim, It does not configure the selected modelsim
Hello, For HDL Co-simulation in MATLAB 2011a, I have two modelsim installed on my machine 1)Modelsim XE 6.2c and then I insta...
11 years 前 | 3 个回答 | 1
3
个回答提问
Error while running FIL Wizard for Atlys Spartan 6 kit.
Hello, I am using MATLAB r2011a, I am able to program FPGA with the FIL Wizard, but when I try to run the model, it shows fol...
11 years 前 | 1 个回答 | 0
1
个回答提问
Error in S-function while running FPGA-in-the-loop, FIL Wizard
Am using MATLAB r2011a, I have made simulink model and using FIL wizard for Atlys Spartan 6 kit. Am successfully able to gener...
11 years 前 | 1 个回答 | 0
1
个回答提问
Simulink block for switching: Multiport switch block not supported in HDL Coder
Hello, I am using Matlab 2011a. In simulink when i use Multiport Switch block, the HDL Compatibility test gives following Error...
11 years 前 | 1 个回答 | 0
1
个回答已回答
I am using MATLAB R2011a, am getting error in HDL workflow advisor Set target interface, FPGA pin specification.
Hi Tim, Thanks for your response. I tried specifying pin numbers as {'1', '2', '3', '4', '5', '6', '7', '8', '9', '10', '11'...
I am using MATLAB R2011a, am getting error in HDL workflow advisor Set target interface, FPGA pin specification.
Hi Tim, Thanks for your response. I tried specifying pin numbers as {'1', '2', '3', '4', '5', '6', '7', '8', '9', '10', '11'...
11 years 前 | 0
| 已接受
提问
I am using MATLAB R2011a, am getting error in HDL workflow advisor Set target interface, FPGA pin specification.
I have selected Atlys Spartan 6 development board. In Set target interface, when i am specifying interface as "Specify FPGA Pin...
11 years 前 | 2 个回答 | 0