Matthew Jaiman

Last seen: 2 years 前 | 自 2022 起处于活动状态

Followers: 0 Following: 0

统计学

Feeds

提问

please help me I want to command the valve on-off with G-code at the mark point I want, where I have 324 mark positions. and make it loop until 324 positions are complete
for i=1:11 tar_point=['X',num2str(pos(i,1)),' Y',num2str(pos(i,2)),' Z',num2str(pos(i,3))]; comd1=['G01 F200 ...

2 years 前 | 1 个回答 | 0

1

个回答

提问

How should I order the commands so that the valve can be opened and closed at the desired position?
for i=1:5 comd2=['M03 on',tar_point]; writeline(s,comd2) tar_point=[' X',num2str(pos(i,1)),' Y',num2str(pos(i,2))...

2 years 前 | 1 个回答 | 0

1

个回答

提问

I want to close the valve in the position I set with the G-code. But what I found was that it was always closed and on.
for i=1:324 tar_point=['X',num2str(pos(i,1)),' Y',num2str(pos(i,2)),' Z',num2str(pos(i,3))];้ comd1=['G01 F200 ',tar...

2 years 前 | 1 个回答 | 0

1

个回答

提问

Can you please tell me how to combine these G-codes and be able to run Delta X Robot through MatLab program? Thanks.
(X,Y,Z) %แถวที่1 writeline(s,'G01 Z-390') writeline(s,'G01 X-78 Y58') writeline(s,'G01 X-55 Y58') writeline(s,'G01 X-32...

3 years 前 | 1 个回答 | 0

1

个回答

提问

How would I be able to code coordinates into a single set of instructions to direct the motion of the Delta X Robot?
s = serialport('COM5',115200,'Timeout',1,'DataBits',8,'StopBits',1,'Parity','none','FlowControl','none'); writeline(s,"IsDelta...

3 years 前 | 1 个回答 | 0

1

个回答