Kushagra
Followers: 0 Following: 0
Feeds
已回答
when to use bdclose versus close_system
close_system cannot close system(or a simulink model) if it has unsaved changes. However, bdclose closes system unconditionally....
when to use bdclose versus close_system
close_system cannot close system(or a simulink model) if it has unsaved changes. However, bdclose closes system unconditionally....
11 years 前 | 0
已回答
Matlab Unit Testing Framework supporting Simulink?
You can use Simulink Design Verifier to generate test cases for simulink models
Matlab Unit Testing Framework supporting Simulink?
You can use Simulink Design Verifier to generate test cases for simulink models
11 years 前 | 0
提问
Accessing elements of Structure
I have a structure which contains various arrays. I want to directly access a particular element of an array. My structure is a...
11 years 前 | 1 个回答 | 0
1
个回答已回答
How to speed up the simulation?
For speeding up simulation, you can use accelerator and rapid accelerator mode. For details, refer to below webinar: https://ww...
How to speed up the simulation?
For speeding up simulation, you can use accelerator and rapid accelerator mode. For details, refer to below webinar: https://ww...
11 years 前 | 0
已回答
How to generate new line instead of \n, when using c printf in Stateflow
try char(10)
How to generate new line instead of \n, when using c printf in Stateflow
try char(10)
12 years 前 | 0
已回答
Writing value to Workspace and taking that value from workspace to be used in another model part
You can either use enabled subsystems as suggested by Kaustubha or you can put both the subsystems in the model and take the fin...
Writing value to Workspace and taking that value from workspace to be used in another model part
You can either use enabled subsystems as suggested by Kaustubha or you can put both the subsystems in the model and take the fin...
12 years 前 | 0
提问
Can model variants be switched while model is running (simulating)?
Is is possible to switch the model which is being referred by model referencing block with variants enabled by changing the valu...
12 years 前 | 1 个回答 | 0
1
个回答提问
How can I access the value of signals at the time of stopping the simulation.
I want to update the initial values of signals(Simulink.Signal) to the values that these signals hold at the time of stopping th...
12 years 前 | 2 个回答 | 0
