![photo](/responsive_image/150/150/0/0/0/cache/matlabcentral/profiles/31133235_1694418555181_DEF.jpg)
Nandhini
Followers: 0 Following: 0
Feeds
提问
Edit poles and zeros in root locus design editor or bode editor
While i am trying to get the bode plot for my input and output from my simulink model i am getting the error as mentioned below ...
3 months 前 | 1 个回答 | 0
1
个回答提问
Scaling of generated duty cycle from simulink to NXP MCU expresso environment
I have developed the FOC model for PMSM, the generated code has been integrated with driver code in NXP MCU expresso environment...
7 months 前 | 1 个回答 | 0
1
个回答提问
Angle estimation from hall sensor using hall decoder block
While i am trying to find the angle from hall sensor signal using hall validity block and hall decoder block, the angle varies o...
8 months 前 | 1 个回答 | 0
1
个回答提问
Error: Integrating the generating code from embedded coder in renesas cubesuite(CS+) environment
Hi, I developed the FOC alogorithm in simulink environment and i generated the embedded code for renesas rl 78, when iam trying...
9 months 前 | 1 个回答 | 0
1
个回答提问
Issue when running the motor from open loop host model - Used custom hardware (Open-Loop Control and ADC Offset Calibration)
Open-Loop Control and ADC Offset Calibration using this link i generated the code from the model for STM32 Nucleo F302R8 bull ru...
10 months 前 | 0 个回答 | 0
0
个回答已回答
Code generation from Simulink to STM32F103 Processor.
Hi,thank you for the support.I tried implementing the open loop model, i generated the code and also integrated it with driver c...
Code generation from Simulink to STM32F103 Processor.
Hi,thank you for the support.I tried implementing the open loop model, i generated the code and also integrated it with driver c...
10 months 前 | 0
提问
Code generation from Simulink to STM32F103 Processor.
I developed a model in simulink for BLDC motor with trapezoidal commutation with PI based speed and current control,I want to co...
11 months 前 | 2 个回答 | 0
2
个回答提问
If else condition is not working properly in matlab function block
function [y1,y2]= fcn(u1,u2,u3,u4) if u1 > 5 y1=u2; else y1=u3; end if u1 < 5 y2=u3; else y2=u2; end I implem...
11 months 前 | 1 个回答 | 0