Shengnan Li
Franklin Electric
Followers: 0 Following: 0
Feeds
提问
Can someone provide a peak current mode controlled buck or boost circuit model in simulink?
Does anyone have a peak current mode controlled buck or boost or other power circuit model?Save me some time. Thanks a lot.
3 years 前 | 0 个回答 | 0
0
个回答提问
how to control Ball valve input signal s
The ball valve model has an input signal s to control ball displacement. I don't understand how it is controlled. for example, i...
8 years 前 | 1 个回答 | 0
1
个回答提问
Why signal changes rise/fall time outside the subsystem block?
I have a subsystem that has a direct look up table in it. the output of this look up table is the upper one in the attached fig....
8 years 前 | 0 个回答 | 0
0
个回答已回答
'to workspace' data length question
Thanks for answering my question. I finally figured out, it is the 'decimation' parameter. It was set to 5. when i changed to 1,...
'to workspace' data length question
Thanks for answering my question. I finally figured out, it is the 'decimation' parameter. It was set to 5. when i changed to 1,...
8 years 前 | 0
| 已接受
提问
'to workspace' data length question
I specified the sample time for 'to workspace' block to be 10^(-5), but it saved only 20k data points, while it should be 100k d...
8 years 前 | 2 个回答 | 0
2
个回答提问
how to get the average frequency for the hysteresis band control?
I am simulating a Direct torque control induction motor. Want to know the average frequency. How do i get it from the switching...
8 years 前 | 1 个回答 | 0
1
个回答提问
Why I get different data from 'to workspace' and 'scope'
I have a switching signal, and a 'edge detector', try to count the pulses. The results from scope looks very good, the 'edge det...
8 years 前 | 1 个回答 | 0