Feeds
提问
Simulink eQEP block for frequency calculation with F28069 MCU
Hi, I'm using eQEP block to read the frequency input of a signal and having some difficulties. Here are the Simulink settings f...
5 years 前 | 0 个回答 | 0
0
个回答提问
LAUNCHXL-F28069M: Does probing work for I2C?
Hi, I have I2C communication setup between two LAUNCHXL-F28069M boards and it works fine. When I use NVIDIA Jetson Nano board a...
5 years 前 | 0 个回答 | 0
0
个回答提问
C2000 I2C communication
Hello, I've been trying to setup I2C communication between two F28069M MCUs and have a problem in receiving more than one byte....
6 years 前 | 0 个回答 | 0
0
个回答提问
eCAN received message status
Hello, I have a software in Simulink that reads and writes CAN messages using LAUNCHXL-F28069MLAUNCHXL-F28069M. Here is a snaps...
6 years 前 | 3 个回答 | 0
3
个回答已回答
How to convert block parameters into input ports in Simulink
Hi David, You're right, it depends on the block. I'm using embedded coder for TI c2000 microcontrollers and would like being ab...
How to convert block parameters into input ports in Simulink
Hi David, You're right, it depends on the block. I'm using embedded coder for TI c2000 microcontrollers and would like being ab...
8 years 前 | 0
提问
How to convert block parameters into input ports in Simulink
Hi, I would like to know if there is any way to convert block parameters into input ports? For example I have a Multi-Port Swit...
8 years 前 | 2 个回答 | 0
2
个回答提问
How can I establish CAN communication using Simulink and TI F28379D processor?
Hi, I'm using Simulink to program TI F28379D processors to establish CAN communication. Right now I'm able to transmit messages...
9 years 前 | 0 个回答 | 0
