![photo](/responsive_image/150/150/0/0/0/cache/matlabcentral/profiles/8765835_1589099227260.png)
Ama Nesciri
Followers: 0 Following: 0
Feeds
提问
Serial communication using Stream Input/Output blocks receives delayed data
As part of a project I am using Simulink to send and receive serial data. The shown setup only concerns the necessary parts for ...
2 years 前 | 3 个回答 | 0
3
个回答提问
Simulink Real-Time TCP strange delay effect of launching models to Speedgoat
I have connected two Speedgoats and wish to send data between them. Right now, I sample a sine wave with sampling time 0.01 and ...
2 years 前 | 0 个回答 | 0
0
个回答提问
Dynamics change depending on whether simulation is run in Simulink or Simulink Real-Time (normal run button)
I'm doing a state-space simulation in Simulink. The results are as expected, until I change to Simulink Real-Time. All of the su...
2 years 前 | 1 个回答 | 0
1
个回答已回答
Simulink Real-Time Speedgoat 'build' error upon 'Run on Target' and missing configuration tab in 'Hardware Settings'
Solved. I had to install Simulink Coder. I found the error by clicking on the vertical three dots in the Diagnostic Viewer and s...
Simulink Real-Time Speedgoat 'build' error upon 'Run on Target' and missing configuration tab in 'Hardware Settings'
Solved. I had to install Simulink Coder. I found the error by clicking on the vertical three dots in the Diagnostic Viewer and s...
2 years 前 | 0
| 已接受
提问
Simulink Real-Time Speedgoat 'build' error upon 'Run on Target' and missing configuration tab in 'Hardware Settings'
I am trying to deploy the Simulink Real-Time example model to a Speedgoat. After establishing a connection with my target device...
2 years 前 | 1 个回答 | 0
1
个回答提问
MATLAB MPC toolbox setting constraints on unmeasured outputs
I am trying to control a fourth order plant using MPC with constraints on my input, my measured output and the unmeasured states...
4 years 前 | 0 个回答 | 0