Installation and Setup

Install hardware support package and set up hardware connection

Before you can start using Communications Toolbox™ Support Package for Analog Devices^® ADALM-Pluto Radio, you must:

Install this support package by following the instructions in Install Support Package for Analog Devices ADALM-PLUTO Radio.
Establish communication between the host computer and the radio by following the steps outlined in Guided Host-Radio Hardware Setup.

Functions

`configurePlutoRadio`	Configure ADALM-PLUTO radio firmware
`findPlutoRadio`	Report information about attached radios
`sdrdev`	Create radio object for specific radio hardware

comm.SDRDevPluto Create object for Analog Devices ADALM-PLUTO radio

Supported Hardware and Required Software
Get an overview of supported hardware and required software products.
Install Support Package for Analog Devices ADALM-PLUTO Radio
Install the Communications Toolbox Support Package for Analog Devices ADALM-Pluto Radio.
Guided Host-Radio Hardware Setup
Follow an automated hardware setup process to establish communication between the host and the radio hardware.
Manual Host-Radio Hardware Setup
Follow a manual hardware setup process to establish communication between the host and the radio hardware.
What to Do After Installation
After you have successfully installed the support package, you can do any of the following:
Setup for Two Radios Connecting to One Host
Set up two radio hardware devices connected to one host computer.
Uninstall Support Packages
Uninstall the support package using the Add-On Manager.

Resolve issues encountered while installing or using the features of the support package.