Exchanging Ethernet Data with STM32xx Based Boards

Introduction

In this example you will learn how to use TCP Send, TCP Receive, UDP Send and UDP Receive blocks to send and receive Ethernet data with the STM32H73ZI2 board.

This example workflow enables you for exchanging data between Host and the target via Ethernet Communication.

The Ethernet port on the STM32H73ZI2 board supports the IEEE 802.3 standard.

Prerequisites

We recommend completing

Required Hardware

To run this example you will need the following hardware:

The STM32H73ZI2 board provides an Ethernet port. This port can be used for data communication using the lwIP TCP/IP stack.

Hardware and Network Configuration

In this task you will configure the hardware and network properties needed to run this example.

The default configuration of the target models present in this example are configured in STM32CubeMX project to get an IP address at startup using DHCP. This workflow is compatible when both the host computer and the target hardware are connected to a router. If you wish to connect the board straight into your host computer with the Ethernet cable, assign the STM32H73ZI2 board with a static IP address.

Settings for Automatic IP Address Assignment using DHCP

Connect the STM32H73ZI2 board with a network cable to a router for automatic IP address assignment. In this configuration, the host computer also needs to be connected to the same router. This can be done with a network cable or over WiFi.

Ethernet Settings for Static IP Address Assignment

Connect the STM32H73ZI2 Board with a network cable to the host computer. In this configuration, set the controlCARD with a static IP address.

UDP Communication between the Target and the Host Computer

In this task, you will run the Model Fault-Tolerant Fuel Control System example on the STM32H73ZI2 board. The control algorithm runs on the target while the host runs a plant simulation of the system. The target and the host communicate via UDP. The target model receives the fuel system control sensors values from the host model and transmits back the calculated fuel mixture ratio to the host computer.

Models Involved in this Example

1. stm32_udp_target

2. stm32_udp_host

Run the Model configured for the target on the hardware

1. Open the stm32_udp_target.

2. Configure the network properties for the model as described in the previous section: Hardware and Network Configuration.

3. The UDP Send and Receive blocks on the target model are configured to do a transmit broadcast and receive from all IP address in the subnet. You can change this to send to a specific IP address and receive from a specific IP address if you know the IP address of the host computer.

4. On the stm32_udp_target, press Ctrl+B or On the Hardware tab, click Build, Deploy & Start to build, load and run the model on the target.

Run the Host Model and analyze the data

TCP Communication between the Target and the Host Computer

In this task, you will run the Model Fault-Tolerant Fuel Control System. The control algorithm runs on the target while the host runs a plant simulation of the system. The target and the host communicate via TCP. The target model receives the fuel system control sensors values from the host model and transmits back the calculated fuel mixture ratio to the host computer.

Note: For multiple clients at the host to communicate with the board configured as a server, there must be multiple server blocks in the board.

Models Involved in this Example

1. stm32_tcp_target

2. stm32_tcp_host - This model requires Instrument Control Toolbox™.

Run the model configured for the target on the hardware

1. Open the stm32_tcp_target.

2. Configure the network properties for the model as described in the previous task: Hardware and Network Configuration.

3. On the stm32_tcp_target, press Ctrl+B or on the Hardware tab, click Build, Deploy & Start to build, load and run the model on the target.

Run the Host Model to receive and analyze the data

See Also