Measurements and Testbenches

Measure and verify gain, noise figure, and intercept point

Measurement of properties such as gain, noise figure, and intercept points (IPs) in RF systems is crucial to the system design and analysis. Such measurements are accomplished by placing a device under test (DUT) in a testbench. Use the testbenches blocks to measure RF properties and verify the response of the DUT.

Blocks

Transducer Gain Testbench	Measures transducer gain of system
Noise Figure Testbench	Measures noise figure of system
OIP3 Testbench	Measure output third intercept point of system
IIP3 Testbench	Measure input third intercept point of system
OIP2 Testbench	Measure output second intercept point of system
IIP2 Testbench	Measure input second intercept point of system
S-Parameter Testbench	Measure S-parameters of system

Featured Examples

Validating IP2/IP3 Using Complex Signals

Run a two-tone experiment to measure the second- and third-order intercept points of an amplifier.

Open Script

Spot Noise Data in Amplifiers and Effects on Measured Noise Figure

A test bench model to describe the noise introduced by a 2-port device.

Open Script

Analysis of Frequency Response of RF System

Analyze the frequency response of an RF system.

Open Script

Measure S-Parameter of Nonlinear System

Use the S-Parameter Testbench block to measure the S-parameters of a nonlinear system. The system shown here includes a device under test (DUT) with a linear filter followed by a nonlinear amplifier. The system allows an external steady state input that is switched off initially. When the DUT is nonlinear, the stimulus signal created in the S-Parameter Testbench block must be small enough to operate in the linear region.

Open Script