How to get amplitude of the Signal in 1-phase PLL (Simulink PowerSystems blockset by Pierre Giroux)
7 次查看(过去 30 天)
显示 更早的评论
Hello,
I'm currently using PLL available from matlab simpowersystems to simulate 1-phase inverter for PV connected to grid system. There are 3 Outputs from this PLL model: frequency, wt, and sin_cos in vector form.
My problem is: I need the signal amplitude? I'm actually trying to figure out where's the Vout of the Phase-locked loop?
Can someone tell me how to get the amplitude ?'
thank U very much!
akki
0 个评论
回答(1 个)
Dallas Perkins
2023-10-13
Hi Akki,
I would take a look into the "Sensors and Measurements" library to see if one of those blocks will get you the amplitude that you need. You could use something like the RMS block directly, or feed the output of your PLL into something like a Fundamental (PLL-Driven) block.
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Circuit Envelope Simulation 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!