Why does Model Configuration Parameters GUI not opening and generating errors in Simulink R2012a and R2013b
4 次查看(过去 30 天)
显示 更早的评论
Similar to a couple previous posters, I cannot open the "Configuration Parameters" GUI in all my SIMULINK models (as has been the case for the last few months). I get this message "Cannot create config set dialog" in the command window. The problem started in March/April 2014 when I loaded R2013b since R2012a stopped opening in a reasonable amount of time. I tried to delete it as this release was worse and reload R2012a since it had worked, but in both cases (after many installs/uninstalls), the problem persisted.
I tried installing the "windows?" tgt file to no avail. Right now, I can run new models based on their defaults (example: variable step, ODE45 solver and 1000 data point limit, but I can't even change these due to no GUI).
I did try a few of the previous suggestions:
>> openDialog(getActiveConfigSet(gcs)) Warning: Detected 1 error(s) in Simulink.ConfigSet.getDialogSchema: Attempt to reference field of non-structure array.
Cannot create config set dialog >> get(getActiveConfigSet(gcs)) Description: '' Components: [9x1 Simulink.ConfigComponent] Name: 'Configuration'
Any help? It's much appreciated, this is annoying!
0 个评论
回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Simulink Environment Customization 的更多信息
产品
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!