control a simulink from a continuous sensor input handled by a matlab script

Tsige alemayoh

2021 9 22

0 个回答

5 次查看（30 天）

0 个投票

I want to send input signals to a simscape model through from my infinite loop in matlab script. Any ideas?

2 个评论
显示无隐藏无

Shayan Sepahvand 2021-9-22

编辑：Shayan Sepahvand 2021-9-22

If you are using an arduino module, there is a package for that in simulink. Download it and there is a block for reading input data from a sensor. You can convert this simulink signal to a Simscape and do the rest of your simulation.

Hope it works for you.

Tsige alemayoh 2021-9-22

Thank you for your reply. Unfortunately, I am using wearable motion sensors (Xsens Awinda), where a hub connected to the computer sends the data to the script, but I couldn’t send these data to my simscape skeleton mechanism continuously on a while loop.

请先登录，再进行评论。

请先登录，再回答此问题。

Follow Question