I need to use HDL Coder and Embedded Coder for my Zynq board. I did install the following hardware support packages.
- HDL coder for Xilinx Zynq
- Embedded coder for Xilinx Zynq
- Simulink Coder
- Matlab coder
After installing, try to do the hardware setup.
It writes the image into the SD card but while verifying I am getting connection failed message and i am not able to test the netwrok connection.
I did the hardware setup with the following scenarios also,
- Using Ethernet USB 3.0 dongle
- Connecting both host PC and Zynq board via Router
- Connecting Both Host PC and Zynq board via common LAN
- Given Static IP address to the Zynq board used
But still getting the same error, Activation connection Failed.
I am using UBUNTU 18.04 version and I need to do the network connection in the same.
Thanks in Advance.
