Problem vertically aligning data in a table using fprintf
8 次查看(过去 30 天)
显示 更早的评论
I'm putting my meshgrid to a table and I'm trying to make it look more presentable. I can't seem to figure out how to get them to line up vertically. My current code is:
for i=1:11
fprintf('%2d %3.2f %3.2f %3.2f\n', t(i),X(i),X(i+11),X(i+22))
end
2 个评论
采纳的回答
Walter Roberson
2011-10-2
Do not put any spaces in your format. Instead, increase the "3" in your "%3.2f" to indicate the total number of characters to the right that you want the right edge of that column to be over by. For example, with %15.2f the right-hand side of the numbers would be the 15th character to the right of the previous column.
(Note: more characters will be used if required by the data value, such as if you were to try to print 1E42 with a 15-character fixed-point format.)
更多回答(1 个)
Image Analyst
2011-10-2
Check your fonts: File/Preferences/Fonts. Maybe you're using a proportional font when you need a monospaced font.
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Structures 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!