清空筛选条件
清空筛选条件

Mexw64 file not found in matlab foc example

4 次查看（过去 30 天）
KW YAN
KW YAN 2022-6-30
评论： KW YAN 2022-10-10
Hi,
I have been trying to run this example from matlab for FOC with a zynq evaluation board with my Linux PC. However, I see the following error when I tried to run the first task:
"Error in S-function 'focZynqTestBench/Motor_And_Load/motorAndLoadSFun_sfcn': S-Function 'motorAndLoadSFun_sf' does not exist"
After fighting with it for some time, I then switched to a laptop with windows OS, and I run the same example again. Then magic happens, it works without an error.
I am wondering if anyone could help to resolve the issue under Linux? Any suggestions would be highly appreciated! Thanks!
Best Regards,
Kelvin

请先登录，再回答此问题。

采纳的回答

Kiran Kintali
Kiran Kintali 2022-10-7
The example ships mex files only for Windows. You need to have necessary products such as Simscape in place to rebuild mex on other platforms.
Feel free to reach out to support for additional help.
  1 个评论
KW YAN
KW YAN 2022-10-10
Thanks Kiran for the help. This is very useful information to know!
Best Regards,
Kelvin

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Xilinx FPGA and SoC Devices 的更多信息

标签

产品


版本

R2022a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by