i dont understand the error here, where do i put the parantheses??
1 次查看(过去 30 天)
显示 更早的评论
% The command below loads the following variables:
% y: vector of output data
% t: vector of corresponding times
% yss: steady-state output
load variables.mat
S=stepinfo(y,t,yss)
% Estimate the parameters of the underdamped, second-order system:
zeta = (-log(S.Overshoot/100))/((pi^2 +(log(S.Overshoot/100)) ^2) ^0.5) % damping ratio
wn = pi/((S.PeakTime)(1-(zeta)^2)^ 0.5) % natural frequency (in rad/sec)
K = yss(wn)^2 % gain
0 个评论
回答(1 个)
the cyclist
2022-11-30
It looks like on this line of your code:
wn = pi/((S.PeakTime)(1-(zeta)^2)^ 0.5)
you are assuming that MATLAB will understand that
(a)(b)
means you should mutliply a and b, but that is not valid MATLAB syntax. Perhaps you meant
wn = pi/((S.PeakTime).*(1-(zeta)^2)^ 0.5)
?
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Legend 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!