清空筛选条件
清空筛选条件

I am getting an error 'Output Port 1' of 'Wind_Turb​ine/Scopes​/Blade Load Scopes i not connected." when i run the model below but I'm not sure where to connect the in/output

1 次查看（过去 30 天）
Karam Karas
Karam Karas 2023-4-7
回答： Dimitri MANKOV 2023-4-11
I am getting an error 'Output Port 1' of 'Wind_Turbine/Scopes/Blade Load Scopes i not connected." when i run the model below but I'm not sure where to connect the in/output ?

请先登录，再回答此问题。

采纳的回答

Dimitri MANKOV
Dimitri MANKOV 2023-4-11
Hi Karam,
It looks like these output ports are not used anywhere in your model, so you can simply delete them to get rid of the warning message.
I hope this is helpful!
Dimitri

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Simulink 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by