Problem save
显示 更早的评论
Hello, I have a very simple question. I want to save a variable of the workspace as an ascii file. I make the following request ("a" is a int16 variable):
save a.txt a -ascii
but I get the following message
Warning: Attempt to write an unsupported data type to an ASCII file. Variable 'seriesb' not written to file.
The variables stocked as int16 are not supported by the "save" command? I want to save my variables as int16 and not double ( because I don't want waste too much space), or the same I want just numbers without digits... what should I do?
thank you very much for your help
采纳的回答
Jan
2011-2-24
2 个投票
If you do not want to waste too much space (what does the GB diskspace cost at the moment?), save your data in binary format, not in -ASCII. Then an int16 needs 2 bytes. As ASCII the int16 -32768 needs 6 bytes plus a delimiter!
What are numbers without digits? Do you mean integers?
Perhaps it is better to use DLMWRITE or FPRINTF to write your files. Then you have more control over the format.
更多回答（1 个）
Matt Tearle
2011-2-24
If you want ascii, why not just write out using fprintf?
fid = fopen('a.txt','wt');
fprintf(fid,'%hd\n',a);
fclose(fid);
6 个评论
Jan
2011-2-24
What is the %hd format?
Jose Luis
2011-2-24
Jan
2011-2-24
'a.txt' is not a variable, but a string. It is the name of the output file. And you write the variable "a" into the file. Just try it and you will see, what happens. The questions about FOPEN are very basic, so I suggest to read the "Getting Started" chapters of the documentation.
Matt Tearle
2011-2-24
@Jan: according to the doc, it's a signed integer "16-bit base 10 values". Not having really used uint16s for anything, I don't know any more than that, but it sounds like the right format!
@Jose: see Jan's reply. That code does exactly what "save a.txt a -ascii" would do if int16 was a supported type (ie write the variable "a" to an ascii file "a.txt" using an integer format.
Jan
2011-2-24
@Matt: ? I meant, that Jose would benefit from reading the Getting Started chapters.
Matt Tearle
2011-2-24
Gah, we need threaded comments! That was in reply to "What is the %hd format?"
类别
在 帮助中心 和 File Exchange 中查找有关 Low-Level File I/O 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
