how to perform frequency shift or frequency correction in simulation using HDL NCO and LOOKUP table(LUT) in order to generate HDL code
6 次查看(过去 30 天)
显示 更早的评论
for the below mentioned exponential part contain code,
% 5MHz carrier
fs = 7.68;
tdw=LTE5_3_1.waveform;
%% SHOLDER REMOVING
shape5_out = conv(tdw,shape5);
%% UPSAMPLING AND LOW PASS FILTERING
fs3 = 491.52;
up5_out = interp(shape5_out,64);
%% NCO operation
fc4 = 40; %shift by 40 Mhz
for ii = 1:length(up5_out)
carr_1shifted(ii) = up5_out(ii).*exp(1i*2*pi*fc4/fs3*ii);
end
data_complex = complex(real(up5_out), imag(up5_out));
complex_timeseries = timeseries(data_complex);
0 个评论
采纳的回答
更多回答(0 个)
另请参阅
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!