How can I receive a particular device signals using USRP?
2 次查看(过去 30 天)
显示 更早的评论
I am receiving signal from USRP using MATLAB, but I only want to receive the signal of a particular device ie: Micaz how can I do that when multiple devices in the room are operating at the same frequency?
2 个评论
回答(1 个)
Walter Roberson
2023-10-19
If you have the cooperation of the device you want to talk to, then see techniques such as those described at https://www.mathworks.com/help/supportpkg/usrpradio/ug/packetized-modem-with-data-link-layer.html . That permits you to create data links -- so each packet of data to be sent out would be tagged with it source and destination link address, and data that is not part of the flow should (ideally) be dropped by the link. Or at the very least you would be able to tell where the packet is from and drop the packet.
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Communications Toolbox 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!