How to convert custom simulink blocks (with inports and outports created for accessing hardware interfaces) inside a subsystem into non-virtual blocks?

3 次查看（过去 30 天）

Harshal Pawar 2024-4-3

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/2102541-how-to-convert-custom-simulink-blocks-with-inports-and-outports-created-for-accessing-hardware-inte

评论： Fangjun Jiang 2024-4-10

I'm working on a project which has custom simulink blocks (with inports and outports created for accessing hardware interfaces) within subsystem. But embedded coder didn't generate code for it stating its a virtual block. So how to convert these virtual blocks (Inports and Outports) inside a subsystem into non-virtual blocks? Or is there any other way so that embedded coder will generate code for it.

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Fangjun Jiang 2024-4-3

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/2102541-how-to-convert-custom-simulink-blocks-with-inports-and-outports-created-for-accessing-hardware-inte#answer_1436026

Select the Subsystem block, right click, select "Block Parameters (Subsystem)", check "Treat as atomic unit".

This is one of the ways to change between virtual and non-virtual.

6 个评论
显示 4更早的评论隐藏 4更早的评论

Harshal Pawar 2024-4-10

AnalogInputLib.slx

Hi..Attached is the one of the Custom Block library file and as suggested below is the snap of the same block where "Treat as atomic unit" is alredy checked. But still issue is there.

Fangjun Jiang 2024-4-10

This block is an empty Subsystem block. There are no Port blocks inside. The port icon and label are from the "mask" of the Subsystem block. Select the block, right click, select Mask, Edit Mask, look at the Icon panel.

Thare are nothing there.

There are some codes related to the mask initialization but nothing indicates anything related to the embedded code generation.

请先登录，再进行评论。

请先登录，再回答此问题。