清空筛选条件
清空筛选条件

High Rotor speed and oscillating troque

2 次查看（过去 30 天）
Hassan Ali
Hassan Ali 2024-4-24
回答： Dr Narayanaswamy P R Iyer 2024-4-24
Hey,
When running a motor through inverter (both parameterized thus non-ideal), the starting speed in RPM reaches approximately 1500 RPM in 0.02sec and and oscilates, it should increase gradually. Moreover, I have given a load torque signal, but liek speed torque is oscillating instead of become stable even after few seconds.
What could be the issue here. The speed and torque snapshots are attached here.

请先登录，再回答此问题。

回答（2 个）

Dr Narayanaswamy P R Iyer
Hi: It all depends upon the model configuration such as whether the model is open loop or closed loop and whether any speed or torque controllers are used in the model etc.
P.R. NARAYANASWAMY.
DR. N P R IYER
EMAIL: nswamy.iyer@gmail.com
  1 个评论
Hassan Ali
Hassan Ali 2024-4-24
its open loop, no controller is used yet. The switching is done through simple SPWM applied to the inverter.

请先登录，再进行评论。

Dr Narayanaswamy P R Iyer
Hi: I can't predict anything unless I am able to see the model.
P.R. NARAYANASWAMY.
DR. N P R IYER
EMAIL: nswamy.iyer@gmail.com

社区

更多回答在  Power Electronics Control

类别

在 Help Center 和 File Exchange 中查找有关 Parameterization Methods 的更多信息

标签

产品


版本

R2024a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by