Pixhawk 6c : monitor and tune error when using telemtry

9 次查看（过去 30 天）
성 신
성 신 2024-7-29
回答： Subhajyoti 2024-8-7
I'm currently using matalb2024a and using pixhak6c.
I want to control without using Radio Control, so I planned to use telemetry radio.
When monitor and tune simulation is started using USB (COM11), it works normally, but it does not connect when telemetry (/dev/ty/S5, COM3) is used.
Error: External Mode Open Protocol Connect command fails
Cause:
Could not connect to target application: XCP internal error: timeout expired, in response to XCP CONNECT command
In the Qgroundcontrol parameter setting, MAV_CONFIG_0 was set to disabled.
Is there a solution?

请先登录，再回答此问题。

回答（1 个）

Subhajyoti
Subhajyoti 2024-8-7
Hi,
This error has been extensively discussed in the community, and there have been numerous proposed workarounds. You may go through the following discussions where you can find valuable insights and potential solutions.
I hope this helps.

类别

在 Help Center 和 File Exchange 中查找有关 PX4 Autopilots 的更多信息

标签

产品


版本

R2024a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by