Creating a new matrix by interpolating two other matrices

Question

Summer 2015-5-9

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/215861-creating-a-new-matrix-by-interpolating-two-other-matrices

评论： Summer 2015-5-10

Hello,

I need to write a code that creates a new matrix C based on the values of matrix A and B, where A and B are 61x10 matrices. Each column of the matrices represents a variable that is common for both A and B and needs to be computed for the new matrix C by interpolating between the columns of these two matrices.

I need to formulate this as a matlab code, but not sure how to start. Do I need to use any built-in function to do the interpolation, or would it be fine to write the interpolation function by myself? Also, I have a total of 10 columns (corresponding to 10 different variables), how do I write the for loop such that the calculations are done for each of the variables (columns) over their 61 values (rows)?

I hope my question makes sense. Thanks in advance.

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

dpb 2015-5-9

1
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/215861-creating-a-new-matrix-by-interpolating-two-other-matrices#answer_178467

在 MATLAB Online 中打开

The beauty of Matlab is that it is vectorized to operate over arrays so you really don't have to do anything special. BUT, you do have to define the problem well enough to have a solution (the Mind Reading Toolbox is yet to be delivered :) ).

What is the interpolating variable between the two arrays? If a simple average is sufficient then

C=(A+B)/2;

works; otherwise add an appropriate weighting to A and B--

C=w*A+(1-w)*B;

for

0<w<1

(The average is just w=0.5, of course)

3 个评论
显示 1更早的评论隐藏 1更早的评论

dpb 2015-5-9

在 MATLAB Online 中打开

And, BTW, if w is dependent upon the position rather than a fixed value overall as the average or above, then use the "dot" operators..

C=w.*A+(1-w).*B;

where w has the same dimensions as A and B.

Summer 2015-5-10

Noted. Thank you.

请先登录，再进行评论。

Answer 2

Image Analyst 2015-5-9

1
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/215861-creating-a-new-matrix-by-interpolating-two-other-matrices#answer_178465

在 MATLAB Online 中打开

What's wrong with the obvious averaging????

C = (A+B)/2;

3 个评论
显示 1更早的评论隐藏 1更早的评论

Image Analyst 2015-5-9

Ah - a key bit of information you didn't explicitly state (though I wondered about before posting). What is w?

Summer 2015-5-9

Sorry for that. My w in this case is: w= (Q-Q1)/(Q2-Q1), where Q1 is used to generate the first matrix A, and Q2 is used to generate the second matrix B. Q is the new rate for which I need to interpolate the values of the two matrices A and B to generate a new one. All of the Q's are scalar values.

请先登录，再进行评论。