Discrepancy between Simulink and hdl code behaviour

2025 7 31
1 个回答
更新时间：2025 8 7
3 次查看（30 天）

0 个投票

I have modelled a control system in simulink.Used fixed point advisor to get all the datatypes. Runs fine in simulation , no issues. I generate hdl code. Flash the code into my FPGA and outputs are not stable. I Find a oscillatory behaviour. What could be the reason? My inputs are correct without noise.

请先登录，再回答此问题。

回答（1 个）

Kiran Kintali
Kiran Kintali 2025-8-1

0 个投票

Could you reach out to tech support for assistance, or alternatively, share your model here? We’d be happy to take a look and provide feedback. HDL Coder ensures bit-true and cycle-accurate behavior that aligns with the original Simulink model.

2 个评论
显示 无 隐藏 无

Gary
Gary 2025-8-6
Due to the obvious reasons, I will not be able to share the code of the customer. But strange, everything works fine in simulink. But when I fuse into the target, the results go haywire.
Gary
Gary 2025-8-7
Let me elaborate. I have modelled this system with sampling frequency of 2.5KHz. Fixed point width arrived based on the advisor and it works fine as compared to float model. So far so good. Now I simulate the same model with 5KHz and the model works fine as it is able to accomodate the data width. When i generate code and run in target, i get oscillations at the output. When i go back to 2.5KHz sample rate, it works fine. Can anybody explain this?

请先登录，再进行评论。

类别

在 帮助中心 和 File Exchange 中查找有关 Xilinx Zynq Platform 的更多信息

产品

版本

R2019a

标签

提问:

Gary
Gary
2025-7-31

评论：

Gary
Gary
2025-8-7

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by