清空筛选条件
清空筛选条件

Automated Green House Temperature Control

5 次查看（过去 30 天）
Daniel Mersha
Daniel Mersha 2011-11-24
How to write a program which will read and monitor the green house temperature from a temperature sensor and compare it with the threshold temperature 290C.If the temperature in the green house goes up switch the fan on for cooling and if it goes down switch the heater on for heating
  2 个评论
Jan
Jan 2011-11-24
Well, I assume the "green" house will get brown very fast near to 290C.
A simple temperature siwtcher should be able to do this without using a program or even Matlab.

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

Walter Roberson
Walter Roberson 2011-11-24
That sounds like a use for a PID Controller, or perhaps just some Fuzzy Logic.
I suspect you would not want the continually switching on and off, where the fan starts, the temperature almost immediately decreases, the fan switches on, the non-longer cooled area warms to a fraction over 290, the fan switches on, the fan switches off, the fan motor burns out...
  2 个评论
Jan
Jan 2011-11-24
A bi-metal switch circuit breaker with a weak magnet for a hysteresis will solve the problem. Daniel, if you implement this for a real application, be sure to check out: http://www.mathworks.com/matlabcentral/answers/9073-what-is-your-unusual-use-of-matlab
Walter Roberson
Walter Roberson 2011-11-25
Bah, those engineers, always wanting to throw hardware at problems!!
:-)

请先登录，再进行评论。

更多回答（1 个）

Prasad Kalane
Prasad Kalane 2013-7-19
>> I had a code for plotting data from sensor.(tested on LM35,ARM-LPC2148,MATLAB 2010) >> Pls edit in that code as well as in controller program.
% *************************************************************************
s1 = serial('COM4'); %define serial port
s1.BaudRate=9600; %define baud rate
fopen(s1); %open serial port
clear data; % data must be in a Coloumn vector (do this setting from controller by using delay & next %line ) e.g. [1;2;3;6;7;8;9]
for i= 1 :10 %acquisition of 100 points
data(i)=(str2double(fscanf((s1)))); %read sensor
disp(sprintf('Temperature= %3.2f oC' ,data(i)))
end
fclose(s1);
i=(1:10); plot(i,data,'--rs','LineWidth',1,... 'MarkerEdgeColor','k',... 'MarkerFaceColor','m',... 'MarkerSize',5)
xlabel('Time')
ylabel('Temparature(celcious)')
title('Plot of Temparature Vs Time')
% then use codition of If...end

类别

在 Help Center 和 File Exchange 中查找有关 Heat and Mass Transfer 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by