Fixed-Point Designer tells me that "Magnitude-Angle to Complex" Block is not supported. Why?

16 次查看（过去 30 天）
Arne
Arne 2015-9-18
回答： Kiran Kintali 2020-10-19
Hi, I am trying to convert a Simulink model that contains several "Magnitude-Angle to Complex" blocks to HDL code. When running the Fixed Point Designer tool it fails at step 1.3 "Address unsupported blocks". However, "Magnitude-Angle to Complex" does support fixed point designs if the approximation method is set to "CORDIC", which I did. Are there any other settings that are needed? Or is there a bug in Fixed Point Designer? Thanks, Arne
  1 个评论
Aditya Dodda
Aditya Dodda 2020-9-3
Hi Arne, Thanks for bringing the issue to our attention. You are correct that the block "Magnitude-Angle to Complex" in CORDIC supports fixed-point. The issue is fixed in the new version of Fixed-Point Tool.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Kiran Kintali
Kiran Kintali 2020-10-19
This issue is resolved in R2016b release.

类别

在 Help Center 和 File Exchange 中查找有关 FPGA, ASIC, and SoC Development 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by