how do i use the pll block of simulink to measure frequency?

5 次查看（过去 30 天）
tochukwu victor
tochukwu victor 2016-2-18
回答： Sabin 2024-12-13
Hi, I am trying to use the pll block of simulink to measure the frequency of a variable frequency system but the block always gives me just the value I input as the initial frequency. How can I Use this block to measure a frequency which may/may not have anything to do with the initial frequency? Is there any other way I can measure frequency on simulink?

请先登录，再回答此问题。

回答（1 个）

Sabin
Sabin 2024-12-13
You must tune the PLL such that it works for your use case. Check this Simscape Electrical example for how to use a Sinusoidal Measurement (PLL):
https://www.mathworks.com/help/sps/ug/power-factor-correction-for-ccm-boost-converter.html
In the above example you can see that if you change the initial frequency to let’s say 30 Hz, the estimated frequency will still settle at 60 Hz (system frequency).

类别

在 Help Center 和 File Exchange 中查找有关 Spectral Measurements 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by