How can i change the output power of a wind turbine induction generator in simpowersystems, and how can I measure the output power?
3 次查看(过去 30 天)
显示 更早的评论
Hello I've been trying to change the output power of a wind turbine induction generator from its menu window (shown below), but I can't figure out the change in power in the scopes I can't understand the resulting signals after I changed the nominal power.
Appreciate your help
0 个评论
回答(2 个)
Joel Van Sickel
2020-9-17
Hello Qais,
you will also need to increase the power delivered to the motor. This will show up in the simulation as increase voltage and current.
Regards,
Joel
0 个评论
Ibrahim Athamnah
2022-1-3
Hello Qais,
I have almost the same problem.
If you solve it, please send to me the solution. My email is:
2019979009@ses.yu.edu.jo
0 个评论
另请参阅
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!