How to set up Altera Cyclone V SoC Development Kit for Embedded Coder Support Package?

3 次查看（过去 30 天）
Netanel
Netanel 2016-11-30
评论： Netanel 2016-12-11
I have performed steps successfully until step 9 -connect the hardware
https://www.mathworks.com/help/supportpkg/alterasocembeddedcoder/ug/installation-and-setup.html
but matlab unable to connect the device using JTAG (time-out error) how i need to setup the hardware? how to config the different jumpers on the board?
Netanel
  2 个评论
Netanel
Netanel 2016-12-11
Sorry you are rigth... my corrected question is:
I have performed steps successfully until step 9 -connect the hardware
https://www.mathworks.com/help/supportpkg/alterasocembeddedcoder/ug/installation-and-setup.html
but matlab unable to connect the device using USB-to-UART(time-out error) how i need to setup the hardware? how to config the different jumpers on the board?
Netanel

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Wang Chen
Wang Chen 2016-12-8
编辑：Wang Chen 2016-12-8
Hi Netanel,
Do you mean the serial connection (USB UART) is timing out?
Please set the jumper setting the same as the picture in page 12 of the board User Guide. Please make sure J28, J29, J30 is set the same as the picture.
https://www.altera.com/content/dam/altera-www/global/en_US/pdfs/literature/ug/ug_cv_soc_dev_kit.pdf
  1 个评论
Netanel
Netanel 2016-12-11
Thank Wang!
I have done all this, yet it did'nt work until
  1. unplug the usb cable from USB-to-UART
  2. plug usb cable to the USB Blaster on the board
  3. verify that windows identify the USB Blaster driver(need to be install part of DS-5)
  4. finally re-plug the usb cable to USB-to-UART
i know it sounds not logic but in my case this is the only thing i try and it works! maybe i wrong, but i suggest others that come up with the same issue to try it...

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 ARM Cortex-M Processors 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by