Designing a Sinusoidal pwm using the embedded coder blocks in matlab for the f28335 dsp

Question

Nadia Smith 2016-12-27

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/318323-designing-a-sinusoidal-pwm-using-the-embedded-coder-blocks-in-matlab-for-the-f28335-dsp

评论： Sadaqat Ali 2024-4-3

spwm.jpg

Hello ALL I'm trying to design a sinusoidal pulse width modulation for a boost inverter using the embedded coder blocks. I designed it in matlab and I'm able to see pulses once I simulate the controller in matlab. However when I build and load the program onto the dsp I'm not see anything on the oscilloscope.

I was trying to see if I can use the epwm block to design the spwm but I was unsuccessful. Once I can get this problem solved I can create a unipolar modulation spwm which I would need for my circuit

Can some provide me with some insight in solving this issue?

Thanks!!

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Sadaqat Ali 2024-4-3

Hello,

Yes I can help you. you can contact with me on my Upwork profile

https://www.upwork.com/freelancers/~01700e2d8c8cf84bc5

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

David Ding 2017-1-3

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/318323-designing-a-sinusoidal-pwm-using-the-embedded-coder-blocks-in-matlab-for-the-f28335-dsp#answer_249278

Hello Nadia,

There could be multiple causes as to why you are not seeing the waveform on the oscilloscope. Please try the following:

Did you build the model for this particular DSP hardware target? In order to run the code on the DSP, you must compile the code specifically for this hardware. If you need support packages, please type

>>supportPackageInstaller

to download the required support packages to build your model for this particular DSP

Is the DSP working and connected properly? Try to connect the input to the DSP to some other source that is known to be working, and see if the oscilloscope is displaying any signals
Is the oscilloscope outputting the correct channel? Please enable all channel outputs on the oscilloscope to see if you see any signals

An example regarding working with PWM and DSP is found in the link below:

http://www.mathworks.com/help/supportpkg/texasinstrumentsc2000/examples/adc-pwm-synchronization-via-adc-interrupt-1.html?searchHighlight=dsp%20oscilloscope&s_tid=doc_srchtitle

Good luck!