How do I remove a certain part of my graph?

3 次查看（过去 30 天）
Alec Carruthers
Alec Carruthers 2017-3-3
回答： Walter Roberson 2017-3-3
I'm trying to plot the specific thrust and specific fuel consumption on the same graph. I have horizontal lines that start the graph and each one goes to a different x value. I was wondering if there is a way to start the graph, for each individual curve, after the horizontal lines ends? Basically how to clean this graph up.

请先登录，再回答此问题。

回答（1 个）

Walter Roberson
Walter Roberson 2017-3-3
You can use x values that start where the horizontal line ends.
If necessary, add the desired origin to the existing x values.
However, adding the desired origin will change what is shown with the data cursor, so if you need to have the data cursor show the offset relative to the place the curve begins rather than coordinates relative to the left edge of the plot, then you would need to take more steps.

类别

在 Help Center 和 File Exchange 中查找有关 Graph and Network Algorithms 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by