清空筛选条件
清空筛选条件

How to stop a graph going below zero in

13 次查看（过去 30 天）
Mitul Dattani
Mitul Dattani 2017-4-10
回答： David Goodmanson 2017-4-11
Hi, ive been given a project to do and im new to matlab, I've written out some code for projectile motion but the issue I have is when I draw the graph the y axis will continually go below zero, how do i stop this?
%======================================================================%
%Arrow is fired from a cliff plot its projectile motion 10m above ground at
%20 m/s
%======================================================================%
clear all %clears workspace
angle = 0.4; %Size of angle it is fired at in radians from cliff
V0 = 20; %inital velocity = 20 m/s
g = -9.81; %Gravity force taking up as +ive
t = 0:0.1:4; %time
%t = zeros(30);
h = 10; %height
%Ax = 0; %Vertical Acceleration
Ay = g; %Horizontal Acceleration
%======================================================================%
%xVelocity = V0 * cos(angle);
yVelocity = V0 * sin(angle); %Vertical Velocity
x = t; %x axis = time
y = h + (yVelocity * t + (1/2) * Ay * t.^2); %s = ut + (0.5)at^2
%======================================================================%
plot(x, y);%+10 BECAUSE 10M ABOVE GROUND
%%%%ADD IN LOOP TO STOP WHEN Y AXIS GOES BELOW ZERO THEN INCREASE
%%%%INCREMENTS
%======================================================================%
caption = sprintf('Angle = %.2f radians', angle); %Title of graph defined
title(caption, 'FontSize', 15); %Title of graph inserted
grid on; %Grid on graph
%======================================================================%
% Enlarge figure to full screen.
set(gcf, 'units','normalized','outerposition',[0 0 1 1]);
%======================================================================%
Also how would I then go about making a GUI so it is then an app and I can input my own different starting heights and angles.

请先登录，再回答此问题。

采纳的回答

David Goodmanson
David Goodmanson 2017-4-11
Hello Matui, several ways to do this. If you want to keep the x and y arrays the same length as they are, you could use the first line below and a section of the plot would consist of y=0. If you want to reduce the sizes of x and y you could use the second line. If you want to keep the values of y around for awhile you could use the third line since Matlab does not plot nans.
y(y<0)=0
x(y<0)=[];y(y<0)=[];
x(y<0)=nan;

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 2-D and 3-D Plots 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by