How to solve the 'StopFcn' error when the cause is "Vectors must be the same length."
48 次查看(过去 30 天)
显示 更早的评论
I have got a simulation file for a grid-tie inverter, which I am going to leave its image below. When I run the simulation, I receive the following error:
Error evaluating 'StopFcn' callback of block_diagram 'DC2ACGRID2'.
Caused by:
Vectors must be the same length.
I cannot figure out what vectors are causing this trouble. Any help is very much appreciated.
16 个评论
Walter Roberson
2021-5-13
set_param('YourModelNameGoesHere', 'StopFcn', '')
then save your model.
Lazar Dulovic
2022-6-30
回答(1 个)
Scout Patel
2021-3-31
- Go to the "MODELING" tab on the simulink window.
- In the Center click on "Model Settings".
- Under Data Import/Export UNCHECK the box next to: "Single Simulation output:"
另请参阅
产品
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!