How to use logic between two points with only a negavite slope?

Question

Andrew 2017-8-8

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/351933-how-to-use-logic-between-two-points-with-only-a-negavite-slope

评论： Andrew 2017-8-10

I have a vector that starts at ~84 decreases to ~77 and then increases to ~84 again. I am only interested in the negative slope of this vector! For example, in the image below, I am only interested in the x points between ~2100 and ~9500 as that is the decreasing slope. Using my logic selects both the negative and positive slope. I am sure there are better ways to do this. Any help would be appreciated.

wndwSize = 30;
h = ones(1,wndwSize)/wndwSize;
G = filter(h, 1,file.data.X.signals.values>78.1) & filter(h, 1,file.data.X.signals.values<82.9);

2 个评论
显示无隐藏无

Jan 2017-8-8

What is shown in the diagram? Where do the values 78.1 and 82.9 come from? What does "interested in the negative slope of this vector" exactly mean? What do you need as output?

Andrew 2017-8-8

编辑：Andrew 2017-8-8

Well, the diagram above is from the following image. It is just logic between to points. It is filtered to reduce noise. My reference to the negative slope is the decrease part of the plot below. The positive obviously would be the increasing. I need to only process data between 78.1 and 82.9 in the decreasing section. I want the output to only be "true" there. I will try your answer below.

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Jan 2017-8-8

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/351933-how-to-use-logic-between-two-points-with-only-a-negavite-slope#answer_277209

在 MATLAB Online 中打开

"Negative slope" sounds like:

index = (gradient(file.data.X.signals.values) < 0);

Or do you mean:

v = filter(h, 1,file.data.X.signals.values);
index = (v > 78.1) & (v < 82.9);

I'm not sure about the meaning of the question.

5 个评论
显示 3更早的评论隐藏 3更早的评论

Image Analyst 2017-8-9

Noise is not signal. So how does filtering out noise -- that is, removing noise to get the true signal -- make the data less precise??? The noise made the data less precise (not the filtering), so by not filtering and keeping the noise, that's what will make it less precise. I've never heard anyone say that keeping noise mixed in with their signal made it more precise than the signal alone.

Andrew 2017-8-10

In short, yes, you are correct, it is my noise that is causing issues in regards to the gradient. Only significant filtering would resolve the issue. But it began to change my results file to file by up to 5%. Where I could do it by hand and get more consistent results. Note, I am only mediocre at matlab, and learn pretty much as I go.

请先登录，再进行评论。