i work on dc mg protection i did this mg but when i inject the faults the result is not right why ?????

2 次查看（过去 30 天）

ali noory 2017-10-1

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/359204-i-work-on-dc-mg-protection-i-did-this-mg-but-when-i-inject-the-faults-the-result-is-not-right-why

关闭： MATLAB Answer Bot 2021-8-20

i work on DC Microw Grid, When I build the simulation of this grid as attached. the MG voltage is: 1200 volt (dc grid voltage is 1200) but the wind turbines voltage is dropped to 1140 v when i run the simulation i need to rise this voltage to 1200 of wind turbine. any one know how to make wind turbine voltage 1200??

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Jan 2017-10-1

Do you expect that somebody can answer this question? Most of the readers might not have any idea about what "dc mg protection" is and why you try to inject faults. But nobody can know, what "is not right" means. We do neither know, what you are doing not what you are expecting as result. You have to post the details, before an answer is possible. Therefore I close this question. You can reopen it by editing the text and providing enough information.

此问题已关闭。