PIL simulation mode using LEGO EV3

13 次查看（过去 30 天）
Amin Asham
Amin Asham 2018-2-2
回答： Abhinav Aravindan 2024-11-13，1:12
Each time I run my model in PIL mode using LEGO EV3 I get the following Error. "The configuration parameters for this model do not support the following connectivity configurations: Raspberry Pi, Texas Instruments Code Composer Studio (IDE), Texas Instruments Code Composer Studio (TCP/IP), Texas Instruments Code Composer Studio (Serial)"
While the External mode is working very well.

请先登录，再回答此问题。

回答（1 个）

Abhinav Aravindan
Abhinav Aravindan 2024-11-13，1:12
Hi Amin,
Code Verification and Validation with PIL does not seem to be supported for the “LEGO MINDSTORMS EV3 Hardware” due to which you are facing the error. However, you may perform “Monitor and Tune (External Mode) simulations” to tune parameters and monitor a model running on your target hardware as well as “Run Model on EV3 Hardware” using “Build, Deploy & Start”.
For further information, please refer to the links below:

类别

在 Help Center 和 File Exchange 中查找有关 LEGO MINDSTORMS EV3 Hardware 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by