清空筛选条件
清空筛选条件

figure data point access in 2018a

2 次查看（过去 30 天）
Lian
Lian 2018-4-30
评论： Lian 2018-4-30
Sometimes I need to manually remove data points from an existing figure which are zero. It could be done fairly easily in previous releases. However I found that I can no longer do so in 2018a mac version. In particular, in figure property, the YData only shows 1xN array, and I cannot access the numerical values of those plotted points. Is this function removed from this release?
  4 个评论
显示 2更早的评论
Ameer Hamza
Ameer Hamza 2018-4-30
编辑：Ameer Hamza 2018-4-30
@Lian, I am able to edit the property XData and YData from property editor. Can you tell me how are you plotting the figures? Alternatively, if it is not working, refer to my answer below.
Lian
Lian 2018-4-30
I tested a very simple plot: figure, plot(sin(0:0.1:2),'ko-'); I understand that I can do that using command lines, but it is a very wired problem, as it is supposed to be very straightforward. Maybe it is due to the installation of some special toolboxes?

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Ameer Hamza
Ameer Hamza 2018-4-30
编辑：Ameer Hamza 2018-4-30
You can set the properties programmatically using line handles. For example
p = plot(1:10); % p is plot handle and have property XData and YData.
p.XData = 1:10;
p.YData = (1:10).^2;
It will update the line according to new data.

类别

在 Help Center 和 File Exchange 中查找有关 Graphics Performance 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by