Why do I receive error when I run a simulation on Simulink with a PIL block for Arduino Mega and gives that there is no connection with the Arduino board?
2 次查看(过去 30 天)
显示 更早的评论
I tried to run the example "Arduino_PIL_Block"(attached). I created the PIL block and located in the model as shown:
When I started the simulation in "Normal" mode I get the following error:
- Noting that I have no problem when I remove the PIL block and run the model in external mode or deploy the controller to the board after cancelling PIL creation.
- My MATLAB is 2017b 64bit and my OS is Windows 7 64bit.
2 个评论
elio zaccgnino
2022-1-17
I have the same problem. Do you know if this example works with Arduino Uno Board?
Thanks in advance
回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Arduino Hardware 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!