Unable to download noninlined S-function into Arduino-2560

Question

Raja Rout 2012-8-9

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/45670-unable-to-download-noninlined-s-function-into-arduino-2560

回答： Murat Belge 2014-4-10

Hi, I am using "Simulink Support Package for Arduino Mega 2560 Hardware" and it works perfectly fine. Thanks for the support.

I would like to add a non-inlined sfunction. For this i have chosen the noninlined sfunction button inside configuration->code generation->interface pane, but i am unable to generate the code.

Thanks in advance

2 个评论
显示无隐藏无

Kaustubha Govind 2012-8-9

Could you please also specify the error message that you receive?

Raja Rout 2012-8-10

The following error message is generated during code generation

"Block 'untitled2/S-Function' is a non-inlined s-function, which is not supported with the current configuration. Consider selecting the support 'non-inlined s-functions' option on the Configuration Parameters > Code Generation > Interface pane**"

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Rolfe Dlugy-Hegwer 2012-8-28

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/45670-unable-to-download-noninlined-s-function-into-arduino-2560#answer_57322

Try the following: # Press Ctrl+E. # In the Configuration Parameters dialog that opens, select "Code Generation" and then "Interface". # In the Interface pane, select the checkbox next to "non-inlined S-function".

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Eric Bott 2014-4-9

Hi Rolfe, I have a similar problem, but for the raspberry pi. I've tried using this solution, but it appears to invalidate the raspberry pi code deployment setup, after which the option to run the model in external mode disappears, and a dialog offering to automatically re-setup the code generation parameters for raspberry pi is again presented. If the dialog is accepted, then the non-inlined box is automatically unchecked, and run external is again offered. Is there perhaps a minor modification which I could make to a config file somewhere, to override the raspberry pi model deployment non-inlined s-function check, so as to enable running external on the pi with non-inlined s-functions? Best Regards, Eric

请先登录，再进行评论。

Answer 2

Murat Belge 2014-4-10

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/45670-unable-to-download-noninlined-s-function-into-arduino-2560#answer_132931

Non-inlined S-functions are not supported by Arduino, Raspberry Pi or LEGO EV3 / NXT support packages. You can only use inlined S-functions with these support packages.