Is it possible to add a "configurable subsystem" in a library using add_block command ?

function test_add()
model = bdroot(gcb);
config_subsystem = strcat(model, '/config_subsystem');
add_block('configurable_subsystem/template',config_subsystem,...
    'Position', [480, 104, 580, 146]);
set_param(config_subsystem,'MemberBlocks', 'config_1, config_2, config_3');
set_param(config_subsystem,'BlockChoice', 'config_1');
end

I put a configurable subsystem named "template" in a library named "configurable_subsystem.mdl". "template" block is not configured.

I can add it to my library (it contains 3 subsystems named "config_1", "config_2", "config_3") but I can not configure it.

error message is :

??? Error using ==> set_param Cannot set member block list for configurable subsystem instance 'my_lib/config_subsystem'.

Error in ==> test_add at 10 set_param(config_subsystem,'MemberBlocks', 'config_1, config_2, config_3');

Thank you for help.

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Bonneuil Arnaud 2013-1-28

Hi,

I found solution a few mounth ago. I write it here.

The configurable subsystem in the source library should have the parameter "TemplateBlock" set to "master" instead of "self".

请先登录，再进行评论。

Answer 2

Azzi Abdelmalek 2012-8-9

1
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/45674-is-it-possible-to-add-a-configurable-subsystem-in-a-library-using-add_block-command#answer_55849

在 MATLAB Online 中打开

can you writte the code that did'nt work
what is the error message
here my code to add a configurable subsystem named "sub1" to a lib named "answer_lib" from a model named "model1"

add_block('model1/sub1', 'answer_liib/sub1') ,