Reduce time with this

Question

Matlabbey 2012-8-19

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/46311-reduce-time-with-this

hi all!

i've a filter that is used on the data, but there is lots of data! i am hoping to resample the data(ia take every 2nd point), and than filter it. the problem is that i only have half as many data points. how can i use spline on the filtered data to make it back to the original.

for example, say theres 1000 data points. i resample every other data point to have 500. i feed that data into filter, and have newdata. how can i use spline to fit back to 1000 data points? i tried resampling every 1/2 but that is no good.

any suggestions will be helpful

thank you!!

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Azzi Abdelmalek 2012-8-19

编辑：Azzi Abdelmalek 2012-8-19

why filter before resampling?
what kind of filter are u using?

if you are using a filter to just remove eventual noise; and don't affect considerably your initial signal; then you have just to interpolate your 500 data. just respect Shanon theorem for sampling

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Azzi Abdelmalek 2012-8-19

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/46311-reduce-time-with-this#answer_56660

编辑：Azzi Abdelmalek 2012-8-19

在 MATLAB Online 中打开

example

 x=0.2:0.02:10;y=sin(x)  %signal with 500 points % sig
 xi=0.01:0.01:10;  % 1000 points
 yi=interp1(x,y,xi,'spline')  % interpolated signal yi for points xi

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

Answer 2

Matlabbey 2012-8-19

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/46311-reduce-time-with-this#answer_56662

编辑：Matlabbey 2012-8-19

在 MATLAB Online 中打开

It doesnt seem to work. is it because i simply have data and not a function? im hoping that yi will look similar to original data series but filtered. it does something kind of weird. heres what i have for example;

x = [ 1 2 3 4 5 6];
xR = x(1:2:end);
y = filter(xR);
xi = y(1:1/2:end);
yi - interp1(x,y,xi,'spline');

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

Answer 3

Jan 2012-8-19

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/46311-reduce-time-with-this#answer_56665

It is a bad idea to omit half of the data before filtering, because the re-creation of these points by using a spline interpolation creates(!) noise again. In addition the interpolation and will take much more time than filtering the signal in its original rate. If the filtering needs too much time for you, try the faster C-Mex FEX: FilterM.