How do I change the initial condition at time t=0 of an IC block to an external value ?

1 次查看（过去 30 天）
Nikolas Haimerl
Nikolas Haimerl 2019-9-2
评论： Jonas 2019-9-3
I have a similiar Simulink system as in the example shown below. However, I would like the initial velocity at time t=0 to be an external value (not 15 as shown in the example). Is there a way to give the IC block an external value, which is then the initial condition at time t=0?

请先登录，再回答此问题。

采纳的回答

Nikolas Haimerl
Nikolas Haimerl 2019-9-2
hi,
Thank you for your answer. Do you also have a suggestion how to circumvent the issue with the time system ? You were right in the assumption, that my system uses a continous time system.

更多回答（1 个）

Jonas
Jonas 2019-9-2
Hi
You should try the implementation below:
IC_int.png
The IC block with initial condition [0] will make sure your model runs with an initial condition. However, the Add block behind it allows you to give an offset to this initial condition with any value you want. By using the unit delay block with input 0, you remove this offset after the first simulation sample.
The only problem I see is that I think you are using a continuous integrator block, my suggestion was only tested in a discrete time system.

类别

在 Help Center 和 File Exchange 中查找有关 General Applications 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by