清空筛选条件
清空筛选条件

Simulink Interface with couple of other Softwares ?

1 次查看（过去 30 天）
Vishal P
Vishal P 2012-10-9
I have problem in finding results to my softwares, as I have been using 2 softwares and MATLAB as a co-junction in between those softwares. So basically 1st software sends data to MATLAB via interface and later MATLAB modifies this data a bit and sends to 2nd software. i.e 1st to Simulink and than Simulink to 2nd, but the problem is my 2nd software crashes which inturn Simulink crashes too. Any Idea in solving this problem ?
Also with Set Path is it only once or we can do it twice ?
As I am Using Matlab R2011a
Thank you for your time.
Regards,
Vishal

请先登录，再回答此问题。

回答（1 个）

Sachin Ganjare
Sachin Ganjare 2012-10-9
  4 个评论
显示 2更早的评论
Vishal P
Vishal P 2012-10-9
Thank you again,
My first model i.e 1st Software is providing o/p data as Speed and Torque which I am sending to MATLAB via interface, than with few changes in Matlab model I send this speed and torque data to 2nd Software.
So basically my 1st software gives out the results and when I run the 2nd software co-jnction with simulink it crashes out both.
Sachin Ganjare
Sachin Ganjare 2012-10-9
编辑：Sachin Ganjare 2012-10-9
As I understand this proces of sharing data is continuous.
Also could you elaborate on these interfaces in particular, because current information is too vague to comment further.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Simulink Functions 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by