I kept on getting error that says "Error in port widths or dimensions. 'Output Port 1' of 'simulink_controller/Sum2' is a [2x2] matrix."

7 次查看（过去 30 天）

显示更早的评论

Pramod Sapkota 2020-5-30

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/538571-i-kept-on-getting-error-that-says-error-in-port-widths-or-dimensions-output-port-1-of-simulink_

评论： Pramod Sapkota 2020-5-31

How can I solve the mentioned error? I couldn't figure out as I am new to simulink.

Thank you.

3 个评论
显示 1更早的评论隐藏 1更早的评论

Pramod Sapkota 2020-5-30

编辑：Pramod Sapkota 2020-5-30

Pramod Sapkota 2020-5-30

This is my simulink model. I have code written in matlab for lqr controller with non zero set point. I have 2 states x1 and x2 but my output of interest is x2 only. I get two errors :

Error in port widths or dimensions. 'Output Port 1' of 'simulink_PNZSP_controller/Sum2' is a [2x2] matrix.

Component:Simulink | Category:Model error

Error in port widths or dimensions. Invalid dimension has been specified for 'Input Port 1' of 'simulink_PNZSP_controller/integrator'.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Walter Roberson 2020-5-30

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/538571-i-kept-on-getting-error-that-says-error-in-port-widths-or-dimensions-output-port-1-of-simulink_#answer_443307

Pass the output of the Sum2 block through a Selector block https://www.mathworks.com/help/simulink/slref/selector.html

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Pramod Sapkota 2020-5-31

I tried using that block still, it shows the same error since the error is shown in the output port of sum block before output reaches the selector block.

请先登录，再进行评论。

请先登录，再回答此问题。